Figure 3-40 Policy Routing
The following items are displayed on this screen:
General
Protocol:
Select the protocol for the entry in the drop-down list. If the protocol you
want to set is not in the list, you can add it to the list on 3.3.4.4 Protocol
page.
Source IP:
Enter the source IP range for the entry. 0.0.0.0 - 0.0.0.0 means any IP is
acceptable.
Destination IP:
Enter the destination IP range for the entry. 0.0.0.0 - 0.0.0.0 means any
IP is acceptable.
Source Port:
Enter the source Port range for the entry, which is effective only when the
protocol is TCP, UDP or TCP/UDP. The default value is 1 – 65535, which
means any port is acceptable.
Destination Port:
Enter the destination port range for the entry, which is effective only when
the protocol is TCP, UDP or TCP/UDP. The default value is 1 – 65535,
which means any port is acceptable.
WAN:
Select the WAN port for transmitting packets.
Effective Time:
Specify the time for the entry to take effect.
-58-
To Next Page
