41
¾ Notify Type: You can select the notify type among DHCP, Static IP, and PPPoE.
¾ SMTP Server Name: Type the SMTP server name up to 64 characters, or the IP address of
the SMTP server.
¾ SMTP Server Port: You can set port number from 1~65535 according to your mail server.
The default value is 25.
z SSL: It is Security setting. Checking SSL box if the mail server you use has security
restriction.
)
Note:
If you use g-mail as your mail server, you should set 587 as your port number and check SSL box.
¾ Authentication: Select the authentication required when you send an email.
z Off: Select this if no authentication is necessary when an email is sent.
z On: If authentication is necessary when an e-mail is sent, there are SMPT, POP before
SMPT or both three options.
z SMTP: Select this if SMTP authentication is necessary when an e-mail is sent.
z POP before SMTP: Select this if POP before SMTP authentication is necessary when an
e-mail is sent. If this option is selected, the IP Notification page will be different as
following figure shown.
z POP server name: It is necessary when the POP before SMTP is selected in
Authentication. Type the POP (receiving mail) server name up to 64 characters, or type the
IP address of the POP server. This setting is necessary when the SMTP server which
sends e-mails performs authentication using the POP user account.
To Next Page
Loading...
