66
)
Note:
You can set motion detection on motion detection page. (Please go to “Setting → Advance →
Motion detection → Setting”) For more details, you can check Section 7.5. Motion Detection
works only when the MPEG4 function is On.
z Parameter: the parameter of CGI (defined in Setting → Advance → HTTP event →
General → URL) is from your target device. For example, move=down.
z Message: message will show up in the form of Message = PTZ down. If your target device
didn’t support the parameter of message, you can’t see the message. So you can just take
the message as a note. For example: PTZ down.
¾ Effective period: Set the period when the periodical sending is effective.
z Always: The periodical sending is always effective.
z Schedule: You can specify the period when the periodical sending is effective in the
Schedule setting in the other section.
To Next Page
Loading...
