Port SettingsFigure 5-7
The DOS prompt ”TL-SL5428E>” will appear after pressing the Enter button as 6.
shown in Figure 5-8. It indicates that you can use the CLI now.
Log in the SwitchFigure 5-8
Logon by Telnet
■
To log on to the switch by a Telnet connection, please take the following steps:
Firstly CLI commands about configuring Telnet login mode, login authentication 1.
information and Privileged EXEC Mode password should be configured through
Console connection. For more details please refer to the CLI Reference Guide on the
resource CD. Here we take login local mode as an example.
Make sure the switch and the PC are in the same LAN.2.
Click Start3.
→
Run to open the Run window.
Configuration
To Next Page
Loading...
