10
V30"Jqy"fq"K"tguvqtg"o{ "Ceeguu"Rqkpv‚u"eqphkiw tcvkqp "vq"kvu"hcevqt{"fghcwnv"ugvvkpiuA
"
V40" Yjcv"ecp"K"fq"kh"K"hqtigv"o{"rcuuyqtfA"
1) Try to use the default user name and password: cfokp, cfokp;
2) Referring to the file that you have saved in
Hkpkuj last time you configured
the device, the file will show you the user name and password that you have
configured.
3) If the password is still not the correct one, then you can try to restore the Access
Point’s configuration to its factory default settings referring to previous section
V3 and try to reconfigure your AP by following the instructions of this QIG.
V50"Yjcv"ecp"K"fq"kh"K"ecppqv"ceeguu"vjg"ygd/dcugf"eqphkiwtcvkqp"rcigA"
Assign a static IP address 192.168.0.100 for your computer first before logging in the
management page. Here takes the procedures in Windows 7 for example."
With the Access Point powered on,
use a pin to press and hold the
TGUGV button on the rear panel for
5 to 8 seconds before releasing it.
Once the Access Point is reset, the current configuration settings will be lost
and you will need to reconfigure the Access Point.
Note
Go to Uvctv"> Ugvvkpiu > Eqpvtqn"
Rcpgn, and then you will see the
following page.
Click"Xkgy"pgvyqtm"
uvcvwu"cpf"vcumu"
Hold it in for 5 to 8 seconds
To Next Page
Loading...
