12
Now, try to log on to the Web-based configuration page again after the above
settings have been configured. If you still cannot access the configuration page,
please restore your Access Point’s factory default settings and reconfigure your
Access Point following the instructions of this QIG. Please feel free to contact our
Technical Support if the problem persists.
Select Qdvckp" cp" KR" cfftguu"
cwvqocvkecnn{"
Select Qdvckp" FPU" ugtxgt"
cfftguu"cwvqocvkecnn{"
Note
While the reconfiguration is done, you need to change the IP address
settings as below. Then, with the correct hardware connection, you can sur
the Internet successfully.
Select Wug"vjg"hqnnqykpi"KR"
cfftguu"
Click QM"
Enter the 192.168.0.100 into the
KR"cfftguu field, 255.255.255.0
into the Uwdpgv"ocum field
To Next Page
Loading...
