TL-WR1042ND 300Mbps Wireless N Gigabit Router
) Note:
1. After a device is successfully added to the network by WPS function, the WPS LED will keep
on for about 5 minutes and then turn off.
2. Pressing the Wireless On/Off button for two seconds will turn on/off the wireless radio. When
the WIRELESS LED flashes, the wireless function has been enabled. When the WIRELESS
LED is off, the wireless function has been disabled.
1.4.2 The Rear Panel
Figure 1-2 Rear Panel sketch
The following parts are located on the rear panel (View from left to right).
¾ POWER: The Power socket is where you connect the power adapter. Please use the power
adapter provided with this TL-WR1042ND 300Mbps Wireless N Gigabit Router.
¾ WPS: If your client device such as wireless adapter supports WPS (Wi-Fi Protected Setup),
use this button to automatically establish a WPA secure connection between the client
device and the router.
¾ RESET:
There are two ways to reset to the router's factory defaults:
1) Use the Factory Defaults function on System Tools -> Factory Defaults page in the
router's Web-based Utility.
2) Use the Factory Default Reset button: Use a pin to press and hold the RESET button for
8 seconds and then wait for the router to reboot.
¾ USB: The USB port connects to a USB storage device or a USB printer.
¾ INTERNET: This port is where you will connect the DSL/cable Modem, or Ethernet.
¾ 1,2,3,4 (LAN): These ports (1, 2, 3, 4) connect the router to the local PC(s).
¾ Wireless antenna: To receive and transmit the wireless data.
-5-
To Next Page
Loading...
