TL-WR1042ND 300Mbps Wireless N Gigabit Router
4.8.3 Media Server
Choose menu “USB Settings→Media Server”, and then you can configure Media Server on this
page as shown in Figure 4-38.
Figure 4-38 Media Server Setting
¾ Server Name – The name of this Media Server.
¾ Server Status - Indicates the Media Server’s current status, started or stopped. You can
click the Start button to start the Media Server and click the Stop button to stop it.
¾ Name - The display name of this folder.
¾ File System - The file system type on the partition can be FAT32 or NTFS.
¾ Folder - The real full path of the specified folder.
¾ Delete - You can delete the share folder by click Delete.
To set up your media server, please follow the instructions below:
1. Plug an external USB hard disk drive or USB flash drive into this router, and then the screen
will appear as shown in Figure 4-39.
Figure 4-39 Media Server Setting
2. Click the Start button to start the media server, and then the screen will appear as shown in
Figure 4-40.
-49-
To Next Page
Loading...
