TPB TECH 75.080.14.242 INSTRUCTIONS MANUAL
17
The appliance has not been
connected in accordance with the
instructions.
Check the appliance has been connected in accordance
with the instructions
Defect in the electronic system. Dry the control panel area or remove the object.
The indicators are
flashing
The control panel is wet or an object
has been placed on top of the same.
Dry the control panel area or remove the object.
The cooking area
There is a defect in the electronic
system.
Briefly cover the control panel with your hand
to confirm the defect.
indicators are flashing
E2
The cooking area has overheated
and turned itself off to protect the
worktop.
Wait for the electronic system to cool
down and sufficiently and turn it on
again.
* If the defect persists notify the Technical Assistance Department.
Do not place hot pans on the control panel.
Normal operating noise
TPB tech 75.080.14.242 heating technology is based on the creation of electromagnetic
fields which ensure the heat is generated directly in the base of the pan. These pans,
depending on the composition of the same, may emit certain noises or vibrations as
described below:
A deep humming noise like that of a transformer
This noise occurs when cooking at high powers levels. It is caused by the amount of energy
being transferred from the cooking plate to the pan. This noise disappears or diminishes
when the power level is reduced.
A low whistling noise
This noise occurs when the pan is empty. It disappears when water of food is placed in the
pan.
To Next Page
Loading...