EasyManua.ls Logo

TPB Tech 75.08014.242 - Installation Manual

Default Icon
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TPB TECH 75.080.14.242 INSTRUCTIONS MANUAL
18
A crackling noise
This noise arises in pans which are composed of different layer materials. It is due to the
vibrations produced in the surfaces joining the different layers of materials. This noise comes
from the pan. The intensity of the noise may vary in accordance with the amount and manner
in which the food is cooked.
A loud whistling noise
This noise occurs above all in pans composed of different layers of materials as soon as they
are placed under maximum heating power and in two cooking areas at the same time.
This whistling noise disappears or diminishes as soon as the power level is reduced.
The noise of the fan
The cooking plate should operate at a controlled temperature to ensure the correct use of the
electronic system. As such, the cooking plate is equipped with a fan which turns itself on
when the temperature read is high. The fan may also work due to inertia, after the cooking
plate has been turned off, if the temperature is still too high.
The aforementioned noises are normal are a part of TPB tech technology, and do not imply a
defect.
Installation Manual
This appliance must be installed by an authorized person and in compliance with AS/NZS
3000 electrical installation standard and in accordance with all local and national regulations.
This applicance must be installed by an authorized person and disconnection incorporated
in accordance with the national wiring rules AS/NZS 3000.
Connections should be made via a suitable isolator which complies with national and local
safety regulations, and the On/Off switch should be easily accessible after the appliance has
been built in.
If the switch is not accessible after installation (depending on country) an additional means of
disconnection must be provided for all poles.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons.