What to do if my TPI Measuring Instruments analyzer won’t turn off?
If your TPI Measuring Instruments analyzer won’t turn off, it could be due to oxygen or carbon monoxide levels being outside the acceptable limits. To resolve this, allow the analyzer to purge for a longer duration.
Why are the readings erratic on my TPI Measuring Instruments when using oil fired equipment?
If your TPI Measuring Instruments readings are erratic when working on oil-fired equipment, it might be due to the A773 oil filter not being installed or installed incorrectly. Ensure that the optional oil filter (A773) is properly installed.
What to do if Ratio, CO air free, excess air, and efficiency read dashes on my TPI Measuring Instruments?
If the Ratio, CO air free, excess air, and efficiency parameters on your TPI Measuring Instruments read and print dashes, it means the measured values are causing the calculated values of these parameters to be out of the acceptable range. Redo the combustion test. Ensure the measured oxygen level is not above 19.9%. These parameters might not display or be applicable in some tests.
How to fix incorrect efficiency reading on TPI Measuring Instruments?
If your TPI Measuring Instruments efficiency reading is incorrect, make sure that you have selected GROSS efficiency, the ambient probe is plugged into T2, and the correct fuel is selected for the equipment being tested.
Explains analyzer technology, sensors, and general maintenance.
Details the front panel layout, including the LCD display and keypad.
Describes the specific actions of each button on the analyzer's keypad.
Details the back, side, and top views of the analyzer and its components.
Covers analyzer batteries, power on/off, and backlight activation.
Step-by-step guide for performing combustion analysis tests.
Explains how to use the analyzer in Thermometer and Manometer modes.
Procedures for configuring analyzer settings and saving test results.
Methods for retrieving stored data and printing test reports.
Details instrument, probe, and gas measurement specifications.
Information on calibration schedules, service, and product warranty.
Guides on water trap, filter, and flue probe maintenance and checks.
Lists error codes and provides solutions for common operational issues.
Covers sensor initialization, zeroing, and configuration settings.
Procedure for testing carbon monoxide levels in ambient environments.
Chart and facts about carbon monoxide exposure levels and symptoms.
Step-by-step instructions for replacing the analyzer's batteries.
General| Type | Combustion Analyzer |
|---|---|
| Power Source | Rechargeable battery |
| Display | LCD |
| Measures | Temperature |
| O2 Range | 0 to 25% |
| Resolution | CO: 1 ppm, O2: 0.1%, Temp: 1°C |
| Accuracy | CO: ±5 ppm or ±5% |
| Response Time | T90 < 30 seconds |
| Operating Temperature | 0 to 50°C (32 to 122°F) |
| Operating Humidity | non-condensing |
To Next Page
