The loudspeaker output signals from each power stage are available on two mono jack sockets on the rear
panel of the unit, enabling you to disconnect the internal speakers and/or use one or more extension
loudspeaker cabinets for a fuller sound.
CAUTION: The load impedance of the loudspeaker outputs must NEVER be less than 8 ohms.
NEVER connect both sockets to the same speaker cabinet, unless it is a stereo cabinet and the speakers are
separately addressable.
Improper use of loudspeaker loads may cause damage to the amplifier and will invalidate the warranty.
If you are unsure as to the overall load impedance of your cabinets, please contact the Trace Elliot Service
Department on +44 (0) 1621 840959 before proceeding.
FRONT PANEL FEATURES
Input
This is a single high impedance input jack, suitable for passive and active guitars with either single coil or
humbucking pickups.
Channel one volume
Determines the preamplifier volume of channel one. This channel is primarily voiced for clean sounds.
However, as you increase the volume control beyond the ‘3 o’clock’ position the sound starts to become
darker and heavier, especially if you are playing a guitar with humbuckers. With this control on maximum,
channel one will overdrive mildly for punchy rhythm work, but still remain highly responsive to your playing
dynamics and the volume control on your guitar.
As you turn the control down, the sound will increase in brightness - therefore you should balance the
channel volume with the master volume and master boost level to achieve the optimum tonality and degree
of gain.
4
To Next Page
Loading...
