SECTION ONE: ASSEMBLY INSTRUCTIONS
Un-boxing Your Grill:
Carefully remove the staples holding the cardboard box to the wooden shipping skid.
With one other person, carefully lift the box up and over the grill. Cut and remove the
two tie-down straps which hold the grills in place. Remove grills and place in an area
where you will not accidentally step on them.
Removing The Barbecue From the Wooden Skid:
Using a ¼” socket or driver, unscrew the four (4) ¼” hex bolts holding the barbecue to
the shipping skid. Then, with one person on each side of the barbecue, carefully lift
the barbecue off the skid and place it on a level surface.
Installing The Casters:
Lay the barbecue on its back. A clean piece of cardboard or blanket should be placed
Under the barbecue to prevent scratching the finish. Install the four casters by
following the diagram below.
Hanging the Grease Catch Bucket:
Locate the grease drain tube coming out of the bottom of the right end of the barbecue
unit. Hang the grease bucket on the drain tube hook.
Caster Receptacles
Receptacle
IMPORTANT NOTE!
Make sure to install the 2 LOCKING
casters on the front of the unit.
To Next Page
Loading...
