traegergrills.com
|
17
WARNING! Remove all unburned
pellets and ash from inside and
around the repot. (See instructions
for proper handling and disposal of
ash on page 22.)
Plug power cord into an appropriate
grounded electrical outlet and restart
the grill. Pellets should fall into the
repot and the hot rod should begin
to heat (it will start to turn red).
CAUTION! Do not touch the hot rod.
3 4
DANGER! If the grill failed to light
or the re went out, turn the Main
Power switch OFF (O) and disconnect
the power cord. If the grill is still hot,
allow it to cool thoroughly.
Open the door and remove all food,
the porcelain-coated grill grate, the
grease drip tray, and the heat bafe.
WARNING! If at any time the grill fails to light, or the re in the repot goes out while cooking or smoking
and there are sufcient pellets in the pellet hopper, it is important that you follow these steps. Failure to do
so may cause a hazardous "over-ring" of your grill due to an excess of unburned pellets in the repot.
1 2
REIGNITING YOUR GRILL
To Next Page
Loading...
Need help?
General
