traegergrills.com
|
11
INITIAL FIRING INSTRUCTIONS
Remove the porcelain-coated grill
grate, grease drip tray, and heat bafe
from the inside of the grill.
With the Main Power switch in the
OFF (O) position, plug the power
cord into an appropriate grounded
electrical outlet. Once the grill is
plugged in, ip the Main Power
switch to ON (I).
Make sure there are no foreign
objects in the auger. With the grill in
Idle mode, press and hold the UP and
IGNITE buttons simultaneously. The
display will ash “Pri” and the auger
will begin priming.
Check that there is air movement from
the draft inducer fan by placing your
ngers over the repot. If the hot rod
is getting hot, it will turn red.
CAUTION! Do not touch the hot rod.
Press and hold the Center button for
two seconds in Temperature Adjustment
mode to put the grill in the Shutdown
Cycle.
To be used on initial ring or any time the grill runs out of pellets. In order to ensure
proper operation of the grill, you must rst prime the pellet hopper’s auger by allowing the
auger tube to be “charged” with pellets.
1 2
3 4
NOTE: Once you turn on your grill, it will enter Idle mode,
and the display’s dashed border will pulse. This indicates
your grill is awaiting a command, and is not actively operating.
The grill MUST be in Idle mode to prime the auger.
To Next Page
Loading...
Need help?
General
