24
VERSATILE LOWER GRATE
You can change the placement of the bottom grill grate for two
dierent cooking options: Sear Position and Smoke Position.
In Sear Position, the grill grate should be placed at the lowest point
in the grill body cavity, resting on the lowest back brackets and the
lip at the front. This ensures that the radiant heat from the grease
drip tray is maximized and your food has sear marks.
For Smoke Position, place the grill grate on the higher front
brackets, sliding it into the channel at the back. This will allow
the smoke to fully circulate for convection cooking.
KEEP WARM FUNCTION
Keep Warm can be used to pause the cook cycle at any time
during grilling and maintain the grill temperature at 74°C (165°F).
Press the KEEP WARM button to activate the function. Press
KEEP WARM again to resume cooking.
IRONWOOD FEATURES (CONTINUED)
NOTE: The upper grate has two positions, center and back. There
are storage hooks on the rear of the skirt for the upper grate
while not in use.
TRAEGER WiFIRE
>Cook Cycle
>Probe
>Auger
>Pellet Sensor
>Wi-Fi Information
TRAEGER PELLET SENSOR
The Traeger Pellet Sensor monitors the supply of pellets. Once
selected from the menu, it will display the current level of pellets
as a percentage in increments of 5%.
If the Traeger Pellet Sensor is properly connected it will display
“PELLET SENSOR Pellet Level: 100%.” If the Traeger Pellet Sensor
is not properly connected it will display “PELLET SENSOR Sensor
Disconnected Pellet Level: 0%.”
The Traeger Pellet Sensor allows you to check the status of your
pellet level remotely using the Traeger App. This new system will
send you push notifications (TPS Reports) and alarms on your
smart device when your pellets are getting low, protecting your
cook from running out of fuel.
6236 Ironwood OM EN GLOBAL v01.indd 24 8/29/19 2:15 PM
To Next Page
Loading...
Need help?
General
