31
It is time to install the main bars on
the cage. This step require 4 bolts, 4
nuts and 8 cupped washers.
32
Place the 2 long top bars into place.
33
The left and right bars are the same.
NOTE: May be necessary to use a medium
size Phillips screwdriver or punch to align the
mounting holes.
34
Insert the bolt, washers and nuts
through the bars at the front left side
and front right side. Nut should be to the in-
side.
NOTE: DO NOT TIGHTEN HARDWARE YET.
35
Install the right side rear bolt, wash-
ers, and nut. Nut should be to the in-
side.
NOTE: DO NOT TIGHTEN HARDWARE YET.
36
Install the left side rear bolt, washers,
and nut. Nut should be to the inside.
NOTE: DO NOT TIGHTEN HARDWARE YET.
To Next Page
Loading...
