Step Two: Accelerate slowly
When the switch has been turned on and there’s a person on kart, keep
hands on steering wheel and feet on brake and accelerator. Slowly step the
accelerator and you'll feel the kart begins to move forward. Slowly speed up
after the kart get power.
Step Three: Braking
The kart is equipped with disc brakes at rear wheel. To use it you must press
gently until it works. Be careful in using the brakes because the kart will slip or
be out of control if brake too quickly.
Step Four: Stop
It’s best to park kart on a smooth and plane ground to prevent damage
caused by accidentally overturned. Turn off switch and the cover.
Note: pay attention to protect the kart avoiding the damage by weather factors.
Although the electric system is covered, it may not be waterproof. So be sure
to pay attention to rain damage caused by weather.
If the kart is not properly kept, it’s not under warranty service.
Repair and maintenance
As electric bicycles, maintenance cost of the kart is relatively low. However,
proper maintenance keeps the kart in good safety performance. The following
are the parts which need maintenance periodically.
Not exposed to the rain and snow
It is extremely important that the kart should always be kept
indoor, not exposed to the rain and snow. Electric system is not sealed. Water
can cause damage to the power system.
The kart which was wet is not covered by warranty.