solved.
1. Open the controller and air break switch box.
2. Turn the air break switch on.
Wiring worn or compressed in system may cause short circuit.
Water gets into system may cause short circuit.
Adjust the brake
If you feel the brake is soft, or step very hard to get the braking force, you can
adjust the brakes.
Adjust the brakes to increase braking force:
1. Park the kart on flat ground, turn off the engine,
find the brake master cylinder on the left side of
seat on the frame.
2. Remove the cotter pin on the axle pin of brake
master cylinder; take out the fork of pedal arm from
the brake master cylinder arm.
3. Loosen the adjustment nut, and rotate brake arm
fork anticlockwise.
4. Install fork arm to brake master cylinder, and
insert the axle pin.
5. Test braking to see if it’s properly adjusted, if brakes work smoothly, brake
friction block does not touch the brake pads; otherwise it will lead to braking
dragging and wear of brake friction block.
6. If you still feel brake is soft, repeat Step 2 to 5.
7. Once brake is properly adjusted, replace the cotter pin.
Note: Do not drive if brakes do not work properly. If you are unable to adjust
and repair brakes, you may need to replace the brake friction block.
To Next Page
Loading...