EasyManua.ls Logo

TrailMaster cheetah i6 - Tire Pressure Check; Battery Removal and Handling

TrailMaster cheetah i6
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
Check tire pressure
It’s very important to check tire pressure
before ride. Low tire pressure can result in
that the vehicle is not operated properly and
out of control. To check the tire pressure,
gas bar must be placed inside each wheel
rim and remove black plastic cover. Use tire
pressure gauge to check, ensuring tire
pressure is at least 15 pounds but not more
than 20 pounds.
Remove battery
The battery of the kart is removable and replaceable. The procedures below
have to be followed if you want to remove the battery.
1. Open plastic battery box by removing the screws on battery box.
2. Unlock the rubber belt which fixes battery.
3. Remove the terminal by unplugging the cradle. Remove negative terminal
first.
WARNING: Do not touch the negative cable connecting positive cable. This
may cause a fire.
4. Disconnect wiring and terminals, then you can remove the battery.
Warning: lead-acid batteries are used in the kart and it must be handled
carefully. Send used batteries to the place selling the batteries of electric
vehicles. Batteries can not be handled as household waste, nor incinerated,
which may cause an explosion.
Warning: if the battery leaks, do not touch it, because the leaking is corrosive,
toxic and dangerous. If skin or eyes contact the battery, rinse with cold water
for at least 15 minutes and immediately go to hospital for treatment.
Warning: new and old batteries can not be mixed to use. Do not mix alkaline,