LCD display change automatically ,then release.
Enter match receiver mode . The number
changes like “08,09,10,11……”, increasing
automatically .
Ste p 4 : Take the transmitter to close the unmatched
receiver 50~100mm .
Ste p 5 : Press and hold on the Dog selection button .If
you match “1” dog, Press “1” button ; If you
match “2” Dog , Press “2” button ; If you
match “3” dog , Press “3” button .After listen
to 3 “beep” sound from receiver and see green
Led flash slow down , Then release .
Spe cial note : Yo u mus t confirm that listen
to 3 sound “bee p” from unmatched receiver
and see gree n Led flash slow down first ,
then release dog selection button . If you
match receiver failure , you need to cancel
the failure matched receiver first, then
re-match again. .
- 11 -
To Next Page
Loading...