before press transmitter buzz control button.
The Beeper component is loose , send to service center
to repair .
Problem#3: The stimulation seems too high, not
high enough or no feeling at all
The collar strap is not tight enough. Make sure the
contacts points connect the dog’s skin well.
The intensity level is not correct. Change the shock
level.
The batteries are dead. Recharge as needed.
Problem#4: The receiver light changes color to
indicate low battery very quickly
The unit has been left turned on between training
session.
Make sure the receiver is turned off after use.
You are training in very cold weather.
Problem#5: The Remote Trainer doesn’t have range
or the range is significantly reduced.
Either you or the dog is shielded by a metal structure.
Operate it far away from these structure.
The receiver is on backwards. For best range, position
- 18 -
To Next Page
Loading...