the receiver so that the light face toward the dog’s nose.
Radio Interference. Wait a short while then try again, or
move to another area.
Problem#6: The receiver seems can’t receive any
signal or can not work at all
Check the receiver on/off button, make sure the
receiver is turned on.
Check the transmitter , If it is low battery, charge
transmitter first .
Cancel the receiver match , then re-match it with
transmitter . If receiver can not work
too, send back to service center to repair or replace .
Warning:
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
- 19 -
To Next Page
Loading...