Roof and Wall Moisture Scanner R.W.S.
Introduction
The RWS is a hand held, non-destructive, electronic
moisture meter specially developed for non-destructive
moisture evaluation and surveying of built-up or single
ply roofing and EIFS (Exterior Insulation Finishing
Systems).
The Tramex RWS is an effective Moisture Scanner with
2 operating modes, EIFS (Walls) and Roofing, each
mode has 2 ranges of sensitivity, affording you the
opportunity to scan roofing, walls and the building
envelope for excess moisture. In the EIFS mode, the
RWS can also be used on foamed-over roofing systems.
For those familiar with Tramex moisture meters, the
RWS incorporates two of Tramex’s well-known mois-
ture scanners, with additional features and benefits, in
one instrument. These are the Leak Seeker, for Roofing
moisture detection and Wet Wall Detector for Wall
(EIFS) moisture detection.
To get maximum benefit from your TRAMEX RWS, it
is suggested before undertaking a moisture survey, that
you read this manual to familiarise yourself with the
operation, features and capabilities of this multi-mode
non-destructive moisture detection and scanning instru-
ment.
Fig. 1. The R.W.S.
R.W.S.
User Guide
To Next Page
Loading...
Need help?
General
