To Next PageTo Next Page
Need help?Do you have a question about the Trane Technologies 4TCC4024E1000A and is the answer not in the manual?
General| Cooling Capacity (BTU) | 24000 |
|---|---|
| SEER | 14 |
| HSPF | 8.2 |
| Refrigerant | R-410A |
| Cooling Capacity | 2 Tons |
| Voltage | 208/230 |
| Phase | 1 |
Warning about electrical hazards and potential for injury or death.
Warning for qualified personnel regarding electrical shock risks.
Caution about proper grounding for equipment and personal safety.
Caution on using correct tools and refrigerant for R-410A systems.
Warning about operating the unit without access panels.
Notice regarding California Proposition 65 chemical exposure.
Read manual before installation, operation, or maintenance.
Check unit for damage upon unloading and report promptly.
Guide for recharging the system based on subcooling and liquid line temperature.
Procedure for evacuating, weighing, and verifying charge below 55°F OD.
Guidance on unit placement for serviceability, airflow, and mounting.
Instructions for unit placement, curb installation, and ductwork for downflow.
Steps for placing and securing the unit on a ground-level pad.
Procedure for installing the unit on a roof curb.
Steps to change airflow direction from horizontal to downflow.
Safety and procedures for lifting and rigging the unit.
Guide for positioning the unit onto the roof curb.
Instructions for installing the unit on a field-fabricated frame.
Procedure for installing the unit on sleeper rails without a curb or frame.
Guidelines for attaching downflow and horizontal ductwork.
Instructions for installing the condensate drain connection and trap.
Requirements for proper electrical power supply and voltage.
Requirement for an approved weatherproof disconnect switch.
Instructions for running power supply lines and making connections.
Guidelines for routing and connecting low voltage control wiring.
Checklist for ensuring all installation steps are completed before startup.
Steps to start the unit in cooling mode and thermostat settings.
Steps to start the unit in heating mode and thermostat settings.
Overview of automatic heating/cooling cycles and fan modes.
Detailed operation sequence for the cooling cycle.
Detailed operation sequence for heating mode and supplementary heat.
Explanation of the defrost cycle mechanism.
Final inspection points to ensure proper installation.
Periodic maintenance tasks for the owner, including filters and coils.
Recommended annual checks by a qualified technician.
Charts showing liquid and suction pressures at various conditions.
Tables detailing fan performance at different static pressures.
Diagram illustrating the unit's refrigerant flow paths.
Guide to identify primary and secondary causes for system faults.
