EasyManua.ls Logo

Trane Technologies 4TCC4030 User Manual

Default Icon
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
March 2022 1188--EEBB3399DD11--11AA--EENN
Single Packaged Cooling/Electric Heat
13.4 SEER2 Convertible, 2 5 Ton
4TCC4024E1000A
4TCC4030E1000A
4TCC4036E1000A
4TCC4042E1000A
4TCC4048E1000A
4TCC4060E1000A
NNoottee:: “Graphics in this document are for representation only. Actual
model may differ in appearance.”
NNoottee:: “Unit specific Service Facts available online.”
Installation and Operations Manual
Question and Answer IconNeed help?

Do you have a question about the Trane Technologies 4TCC4030 and is the answer not in the manual?

Trane Technologies 4TCC4030 Specifications

General IconGeneral
Cooling Capacity (BTU)30000
SEERUp to 14
HSPFUp to 8.2
Voltage208/230
Phase1
Cooling Capacity (Tons)2.5
Heating Capacity (Tons)2.5
Refrigerant TypeR-410A

Summary

SAFETY SECTION

HAZARDOUS VOLTAGE!

Warning about severe injury or death from improper servicing due to electrical hazards.

SAFETY AND ELECTRICAL HAZARD!

Warning for qualified personnel only, risk of injury or death from improper servicing.

GROUNDING REQUIRED!

Caution about equipment damage or injury from improper grounding procedures.

UNIT CONTAINS R-410A REFRIGERANT!

Warning about hazards and special equipment required for R-410A refrigerant.

SAFETY HAZARD!

Warning about severe injury or death from operating the unit without access panels.

WARNING!

Warning about exposure to chemicals, including lead, known to cause cancer and birth defects.

Charging in Cooling above 55°F OD Ambient

Lifting and Rigging

Ductwork Installation

Electrical Wiring

Electrical Connections

Guidelines for making electrical connections according to local and national codes.

Power Wiring

Instructions for running power supply lines through conduit and connecting them to the unit.

Disconnect Switch

Requirement for an approved weatherproof disconnect switch near the unit.

Control Wiring (Class II)

Pre-Start Quick Checklist

Starting the Unit in Cooling Mode

Starting the Unit in Heating Mode

Sequence of Operation

Final Installation Checklist

Maintenance

Refrigerant Circuits

Troubleshooting Chart

Related product manuals