Trane Technologies 4TCC4030E1000A User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
March 2022 1188--EEBB3399DD11--11AA--EENN
Single Packaged Cooling/Electric Heat
13.4 SEER2 Convertible, 2 – 5 Ton
4TCC4024E1000A
4TCC4030E1000A
4TCC4036E1000A
4TCC4042E1000A
4TCC4048E1000A
4TCC4060E1000A
NNoottee:: “Graphics in this document are for representation only. Actual
model may differ in appearance.”
NNoottee:: “Unit specific Service Facts available online.”
Installation and Operations Manual

Trane Technologies 4TCC4030E1000A Specifications

General

SEER	Up to 14.5
HSPF	8.2
Stages	Single Stage
Refrigerant	R-410A
Voltage	208/230V
Phase	1
Cooling Capacity	30000 BTU/hr
Heating Capacity	30000 BTU/hr

Summary

SAFETY WARNING

SAFETY SECTION

Hazardous Voltage

Warning about severe personal injury or death due to hazardous voltage.

Electrical Hazard

Warning about severe personal injury or death from electrical hazards.

Grounding Requirement

Emphasizes the necessity of proper grounding for equipment and personal safety.

R-410A Refrigerant Warning

Warning regarding R-410A refrigerant and required service tools.

Safety Hazard - Access Panels

Warning about severe personal injury or death if access panels are not installed.

Chemical Exposure Warning

Product exposure to chemicals like lead, known to cause cancer and reproductive harm.

Charging in Cooling above 55°F OD Ambient

Unit Installation

Ground Level Installation

Steps and considerations for installing the unit at ground level.

Convert Horizontal to Down Airflow

Rooftop Installation - Curb Mounting

Lifting and Rigging

Safety warnings and procedures for lifting and rigging the unit.

Placing Unit on Mounting Curb

Rooftop Installation - Frame Mounting

Rooftop Installation - No Curb/Frame

Electrical Wiring

Electrical Connections

Power Wiring

Field Wiring Diagram

Diagram illustrating field wiring connections for the unit and accessories.

Unit Startup

Pre-Start Quick Checklist

A checklist of essential items to verify before starting the unit.

Starting the Unit in Cooling Mode

Steps to start the unit and operate it in cooling mode.

Operating Pressure Checks

How to check operating pressures using gauges and compare to service facts.

Voltage Check

How to check line voltage at the unit while the compressor is operating.

Starting the Unit in Heating Mode

Steps to start the unit and operate it in heating mode.

Cooling Mode Operation

Heating Mode Operation

Supplementary Heat Operation

Demand Defrost Operation

Final Installation Checklist

Maintenance

Owner Maintenance Tasks

Air Filter Maintenance

Condenser Coil Cleaning

Recommended Service Maintenance

Refrigerant Circuits

Troubleshooting Chart