TK 62061-18-IM-EN
27
Preparing the Refrigeration Hoses
1. Cut the hose to the required length. Use the recommended hose cutters. Do not use saws, knives or similar tools.
2. Pass two clips of appropriate diameter over the hose.
3. Lubricate the cylinder of the fitting to be inserted in the hose, using Thermo King refrigerant oil.
4. Manually insert the fitting into the hose. The hose should touch the projecting part of the fitting without going into
it. Clean off excess oil.
5. Place the clamp for the clips into the fitting slot. The clamp is properly positioned when it can rotate within the slot.
6. Place the clips in the clamp arm seats.
7. Close both clips using recommended pincers. Check that the clips are properly positioned and closed (see
drawings).
To Next Page
