To Next PageTo Next Page
Need help?Do you have a question about the Trane 4YCZ5036F1070B and is the answer not in the manual?
General| Model Number | 4YCZ5036F1070B |
|---|---|
| Category | Chiller |
| Cooling Capacity | 36, 000 BTU/h |
| Refrigerant | R-410A |
| Compressor Type | Scroll |
| Type | Air-Cooled |
| Voltage | 208-230V |
| Cooling Capacity (BTU/h) | 36, 000 BTU/h |
| Phase | Single Phase |
Provides an overview of the manual and unit installation guidelines.
Details how to check the unit for damage upon delivery and verify its contents.
Procedure for charging refrigerant in cooling mode at specific ambient temperatures.
Installation considerations for units configured for horizontal airflow.
Installation considerations for units configured for down airflow.
Instructions for installing the unit on a ground-level pad.
Steps for mounting the unit on a roof curb.
Instructions to change the unit's airflow from horizontal to downflow.
Procedures and precautions for safely lifting and rigging the unit.
Instructions for installing the unit on a rooftop frame.
Installation procedure for rooftop units without a curb or frame.
Connecting downflow ductwork to a roof curb.
Connecting downflow ductwork to a roof frame.
Connecting horizontal ductwork to the unit.
Instructions for installing the condensate drain piping.
Schedule and tables for determining gas pipe size and delivery.
Precautions for setting up gas pressure before connecting the unit.
Guidelines for managing gas supply line pressure.
Details on making proper electrical connections to the unit.
Requirements for electrical power availability and voltage.
Requirements for installing a weatherproof disconnect switch.
Instructions for running power supply lines and making connections.
Mandates electrical grounding in accordance with codes.
A checklist of items to verify before starting the unit.
Steps to initiate the unit's cooling operation.
Verifying the line voltage at the unit during operation.
Steps to initiate the unit's gas heating operation.
Describes the automatic cycles for heating and cooling.
Details the operation sequence for the cooling cycle.
A final check to ensure all installation steps are complete and correct.
Tasks the owner can perform for routine unit upkeep.
Maintenance tasks to be performed by qualified service personnel.
Procedure for checking and adjusting gas manifold pressure.
How to adjust the ECM fan motor speed settings.
Understanding the diagnostic codes from the IGN board LEDs.
Explains the flow and operation of refrigerant during cooling.
Steps to take and checks to perform before calling for service.
Contact information for service support.
