Supplementary
Electric Heaters
for TEM4, TEM6, TEM8 and A4AH4 Air Handlers
INSTALLER'S
GUIDE
Models:
BAYHTR1504BRKC
BAYHTR1504LUGB
BAYHTR1505BRKC
BAYHTR1505LUGB
BAYHTR1508BRKC
BAYHTR1508LUGB
BAYHTR1510BRKC
BAYHTR1510LUGB
IMPORTANT — This Document is customer property and is to remain with this unit. Please return to service information pack upon completion of work.
© 2019 Trane
ALL phases of this installation must comply with NATIONAL,
STATE AND LOCAL CODES
18-HB22D1-14
HAZARDOUS VOLTAGE - DISCONNECT POWER BEFORE SERVICING
WARNING:
07/19
PRECAUTIONARY MEASURES
• Avoid breathing fiberglass dust
• Use a NIOSH approved dust/mist respirator
• Avoid contact with the skin or eyes. Wear long-
sleeved, loose fitting clothing, gloves, and eye protec-
tion.
• Wash clothes separately from other clothing, rinse
washer thoroughly.
• Operations, such as sawing, blowing, tear-out, and
spraying may generate fiber concentrations requiring
additional respiratory protection. Use the appropriate
NIOSH approved respirator in these situations.
FIRST AID MEASURES
EYE CONTACT: FLUSH EYES WITH WATER TO RE-
MOVE DUST. IF SYMPTOMS PERSIST, SEEK MEDICAL
ATTENTION.
SKIN CONTACT: WASH AFFECTED AREA GENTLY
WITH SOAP AND WARM WATER AFTER HANDLING.
THIS PRODUCT CONTAINS FIBERGLASS WOOL INSULA-
TION! FIBERGLASS DUST AND CERAMIC FIBERS ARE BE-
LIEVED BY THE STATE OF CALIFORNIA TO CAUSE CAN-
CER THROUGH INHALATION. GLASSWOOL FIBERS MAY
ALSO CAUSE RESPIRATORY, SKIN, OR EYE IRRITATION.
GENERAL
This accessory electric heater is designed to provide power
directly to the unit from the accessory heater's power
supply eliminating the need for additional circuits. The
power and control wiring use a single polarized plug to
connect the heater and the unit. See the Heater Data
table on page 4 for the number of circuits required.
1. Check the unit heater label to confirm that the selected
Heater is approved for use with this unit in the installed
configuration. For some heaters, a corresponding
secondary nameplate label is included. Place the label
within the heater data table on the air handler nameplate.
This is shown in Figure 7.
2. Check the components received for damage. Report
any defects or shortages to the transportation company
immediately.
3. Be sure the power supply agrees with the listing shown
on heater nameplate.
BAYHTR1515BRKB
BAYHTR1516BRKA
BAYHTR1517BRKA
BAYHTR1519BRKB
BAYHTR1520BRKB
BAYHTR1521BRKB
BAYHTR1522BRKA
BAYHTR1523BRKA
BAYHTR1525BRKA
BAYHTR3510LUGC
BAYHTR3515LUGC
BAYHTR3517LUGA
Page 1 of 20 10/16/2019
MOHS, PLANS EXAMINER
REV #1 .
2405 E AINSWORTH AVE B19-2396
INSTALL HVAC SYSTEM/PORT OF PASCO 10/1/2019
By Ben Mohs 10:43, Oct 16, 2019
To Next Page
Need help?
General
