10 ACC-SVN67D-EN
Installation
11. Secure the electric heater element assembly with the necessary amount of screws.
12. Slide the electric heater control panel/access door assembly inward until the rear edge engages
with retaining clips. See Figure 3. For the BAYHTRS, BAYHTRT, BAYHTRU, and BAYHTRW kits,
secure the outer edge with 2 screws. The BAYHTRA, BAYHTRB, and BAYHTRD kits will secure
the control panel with screws at the top against the vestibule panel and against the indoor
divider panel. See Figure 7.
Figure 5.
Figure 6.
GUIDE RODGUIDE ROD
SUPPORT BRACKETSUPPORT BRACKET
LOCATOR TABS
SCREWS NOT
REQUIRED ALONG
THE TOP
SCREWS
FILLER PANEL
SCREWS
To Next Page
Loading...
