6 MCC-SVU01A
Control Operation
Infrared Remote Control
Instructions of remote controller
“ON/OFF”
Open or close the air-conditioner
ECO
Automatically setting 26°C
in cooling or heating mode.
Fan Speed
Reduce fan speed in one gear.
Minimum wind speed will switch to the
automatic wind, and switch to the
highest wind when pressing.
Note :
- Do not place remote controller near heat source such as electric blankets or heating furances.
- Do not place remote controller in direct sunlight.
- Be careful not to drop, otherwise it may cause damage.
- No obstacle between the signal receiver and the remote controller.
- If the signal is received correctly, the air conditioner will issue a “beep” prompt.
- When the remote controller is idle for a long time, the battery should be removed.
- If the remote controller is not available, please replace the new battery “AAA” type and try again.
But if the problem persists, please contact the seller or our authorized service center.
Sleep
Enter the sleep function. Decide
whether to have this function
according to the actual model.
Up and down swinging
Open the external pendulum wind.
Timer
Setting timing ON/OFF.
Temperature reduction
Decrease the setting temperature.
Temperature addition
increase the setting temperature.
Turbo
Turbo not able for MCC model
Left and right swing
Open the internal pendulum wind.
(Not able for MCC model)
Mode
Select modes, including automatic,
cooling, dehumidification, fan and
heating mode.
(Heating mode not able for MCC model)
To Next Page
Loading...
Need help?
General
