MCC-SVU01A 9
Maintenance
Replacing Air Purifying filter
(Option)
Recommend once every three
months.
Information
Airflow volume is reduced when
an air purifying filter have been
installed.
Cleaning the Air Filters
Before inspection and maintenance
of the unit, always set the main
power switch to “OFF” to cut off
power supply.
Cleaning the Unit.
Clean the air conditioner and the
remote control with dry cloth or a
vacuum cleaner. If damp cloth is
used, remove moisture by using
dry cloth afterwoed.
At the Start of the Season
Open the grille by pulling the
latches from the front frame.
Swing the grille open and remove
the air filter out off the grille.
•
•
•
Unclip the grille from the front
frame by pull the latches from
the front frame
•
Swing up the grille until the latches
click into the positions.
•
Check that nothing blocks the air
inlet and outlet of indoor and
outdoor units.
During the OFF Season
•
Cut off the power supply main
swich.
Suggestion :
•
If the filter is dirty, it will cause the
reduction of airflow, the unit is
overload and consume 6% more
of electricity. So, regular cleaning
is necessary.
•
Running the unit without an air filter
can cause malfunctions due to dirt
or dust. Alway install an air filter at
all times.
•
Check that the units are properly
installed.
•
Check that a drainage hose does
not bend or clog.
•
Clean the air filter and other parts.
•
Operate unit in “FAN” mode for
2-3 hours to dry out the inside of
the unit.
Swing the grille open and remove
the air filter out off the grille.
•
Unscrew the filter frame and
remove the air purifying filter
from the filter frame.
•
Re-insert the air filter to the grille,
swing up the grille until the lacthes
click into the positions.
•
Remove the air filter and clean by
vacuum cleaner or if it is very dirty,
wash it with soap water then dry it
up in the shade and make sure it is
completely dry before reinstall it to
unit.
•
Filter Frame
Air Filter Air Purifying Filter
PULL
PULL
To Next Page
Loading...
Need help?
General
