Trane CH530 User Manual

Liquid-Cooled Adaptive Frequency™
Drive
With Tracer AdaptiView™ or CH530/CH531
Control
Installation, Operation, and Maintenance
May 2020
AFDK-SVU01C-EN
SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of
heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training.
Improperly installed, adjusted or altered equipment by an unqualified person could result in death or serious injury.
When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that are
attached to the equipment.

Trane CH530 Specifications

General

Input Voltage	24 VAC
Application	HVAC Systems
Communication Protocol	BACnet MS/TP
Memory	Flash memory for program storage
Display	Backlit LCD
Mounting	Panel Mount

Summary

Introduction and Safety Information

Advisory Definitions and Types

Defines Warning, Caution, and Notice advisories and their implications for safety.

Critical Safety Warnings: PPE and Wiring

Emphasizes essential Personal Protective Equipment (PPE) and safe field wiring practices.

Document Overview and General Information

Trademarks and Revision History

Provides trademark information and document revision history.

General Information and Manual Scope

Outlines manual purpose, required documents, and service information.

AFDK Drive Description and Model Numbers

Explains AFDK drive features, operation, and model nomenclature for clarity.

Drive and Cabinet Components

Enclosure Rating and Environmental Conditions

Details the NEMA 1 enclosure rating and environmental requirements for installation.

Component Locations for Frame 3 Units

Identifies drive cabinet and power module components for Frame 3 units.

Component Locations for Frame 4 Units

Identifies drive cabinet and power module components for Frame 4 units.

Cabinet Dimensions and Features

Provides physical dimensions and features of the drive cabinet.

Installation and Mounting Procedures

Tools and Components for AFDK Retrofit

Lists required tools and additional parts for performing the AFDK drive installation.

Lifting and Mounting Guidelines

Details safe lifting procedures and mounting steps for unit and remote drives.

Plumbing and Heat Exchanger Installation

Covers plumbing connections and heat exchanger setup for drive cooling systems.

Wiring and Control Systems

Corrosion Prevention and Maintenance

Provides guidelines for water quality to prevent corrosion in cooling loops.

Input Power, Grounding, and Control Wiring

Covers wire sizing, routing, torquing, grounding, and standard control connections.

Adaptive Frequency Drive Operation and Control

Explains drive efficiency, surge control, and operational sequences for optimal performance.

Service, Maintenance, and Troubleshooting

Operator and Service Interfaces

Describes AFD operator displays, CH530/531 interface, and TechView service tool.

Pre-startup Checks and Startup Procedure

Lists essential pre-startup checks, startup steps, and test log requirements for the drive.

Troubleshooting Alarms and Fault Codes

Guides on interpreting alarms, diagnostics, fault codes, and troubleshooting drive issues.

Recommended Periodic Maintenance

Outlines visual and operational inspections for ongoing maintenance and system health.

Wiring Schematics