To Next PageTo Next PageWhat to do if my Trane Foundation EBC300 is cooling improperly?
If your Trane Air Conditioner isn't cooling correctly, it could be due to failed cooling and heating set points on the thermostat. Try power cycling the 'R' input. Another potential cause is an open CC1 or CC2 24 Vac control circuit. In this case, check the CC1 and CC2 coils and the Frostat™ status, as well as the LED indicator in LSD.
How to reset cooling and heating lockouts on a Trane Air Conditioner?
Cooling failures and heating lockouts are reset in an identical manner. You can reset the system from the space by turning the 'Mode' selection switch at the thermostat to the 'Off' position, and then turning it back to the desired mode after about 30 seconds. Alternatively, you can reset the system at the unit by cycling the unit power off and then on using the disconnect switch.
General| Category | Air Conditioner |
|---|---|
| Model | EBC300 |
| Refrigerant Type | R-410A |
| Voltage | 208/230V |
| Phase | 1 |
| Cooling Capacity | 36, 000 BTU/H |
Explains safety warnings, cautions, notices, PPE, and field wiring hazards.
Hazards and PPE for working with fiberglass insulation.
Critical warnings and instructions for safely lifting the unit.
Details requirements for roof structure, foundation, and anchoring.
Covers power supply verification, connections, grounding, and filter installation.
Covers FDD, economizer start-up, LLE tests, compressor/heating start-up, and final system setup.
How to clean evaporator, condenser, and microchannel coils safely and effectively.
Emphasizes critical safety precautions for performing service.
