To Next PageTo Next PageHow to reset cooling and heating lockouts on a Trane Foundation GBC210?
To reset cooling and heating lockouts, turn the 'Mode' selection switch at the thermostat to the 'Off' position. After approximately 30 seconds, turn the 'Mode' selection switch to the desired mode, such as Heat, Cool, or Auto. Alternatively, cycle the unit power by turning the disconnect switch 'Off' and then 'On'.
What to do if my Trane Foundation GBC210 is experiencing a cooling failure?
If your Trane Air Conditioner has a cooling failure, check CC1 and CC2 coils and the Frostat™ status. Also, check the status of the LED indicator in LSD. Another solution is to power cycle on the ‘R’ input.
General| Brand | Trane |
|---|---|
| Model | Foundation GBC210 |
| Category | Air Conditioner |
| Language | English |
Defines advisories and covers critical safety for wiring, PPE, and refrigerant.
Mandates EHS policies and warns against water/roof damage.
Details safety measures and first aid for fiberglass wool exposure.
Details safety warnings and procedures for lifting heavy units.
Covers foundation, ductwork, and general installation requirements.
Details power supply, wiring, and external vent hood installation.
Covers filter installation and guidelines for field-installed power wiring.
Details standard wiring and through-the-base electrical option.
Details gas train requirements and operating data for gas heat.
Explains voltage imbalance calculation and electrical phasing checks.
Covers safety for live components and the function of crankcase heaters.
Warns about rotating components and chemical hazards for coil cleaning.
