To Next PageTo Next PageHow to reset cooling and heating lockouts on a Trane Foundation GBC240 Air Conditioner?
To reset cooling and heating lockouts, turn the 'Mode' selection switch at the thermostat to the 'Off' position. After approximately 30 seconds, turn the 'Mode' selection switch to the desired mode, such as Heat, Cool, or Auto. Alternatively, cycle the unit power by turning the disconnect switch 'Off' and then 'On'.
What to do if my Trane Foundation GBC240 Air Conditioner is experiencing a cooling failure?
If your Trane Air Conditioner has a cooling failure, check CC1 and CC2 coils and the Frostat™ status. Also, check the status of the LED indicator in LSD. Another solution is to power cycle on the ‘R’ input.
General| Brand | Trane |
|---|---|
| Model | Foundation GBC240 |
| Category | Air Conditioner |
| Language | English |
Details essential requirements and hazards for field wiring and grounding.
Outlines mandatory PPE for technicians to prevent injury from hazards.
Instructions and warnings for safely lifting and rigging the unit using appropriate equipment.
Critical steps for ensuring proper structural support and preventing collapse during installation.
Verifying power supply compatibility and ensuring proper wiring connections for the unit.
Guidelines for properly sizing and installing the unit's supply power wiring.
Requirements for electrical service protection, disconnect switches, and proper grounding.
Explains the importance of maintaining voltage balance for motor longevity and operational integrity.
Procedures for determining and correcting electrical phasing for proper three-phase motor rotation.
Explains the function of crankcase heaters for preventing oil foaming and ensuring compressor longevity.
Describes the sequence of operation for electromechanical controls during cooling and heating modes.
Provides sequence of operation tables for JADE controls with DCV and enthalpy settings.
Procedures for starting compressors, verifying rotation, and checking pressures.
Recommended procedure for starting the heater with the main gas supply off for initial checks.
Final checks before leaving the unit, including programming, inspections, and securing panels.
Detailed instructions for adjusting and maintaining belt tension for optimal fan operation.
Steps for diagnosing unit issues using the Ignition Module (IGN) and system status information.
Identifies common heating and cooling failures based on Ignition Module LED indicators.
Guidance on interpreting alarm messages from the economizer controller for diagnosis.
Lists fault codes for LLE systems and their corresponding issues.
Details the warranty period and coverage for defects in material and manufacture.
Specifies what is not covered by the warranty and limitations on liability.
