To Next PageTo Next PageHow to reset cooling and heating lockouts on a Trane Foundation GBC180 Air Conditioner?
To reset cooling and heating lockouts, turn the 'Mode' selection switch at the thermostat to the 'Off' position. After approximately 30 seconds, turn the 'Mode' selection switch to the desired mode, such as Heat, Cool, or Auto. Alternatively, cycle the unit power by turning the disconnect switch 'Off' and then 'On'.
What to do if my Trane Foundation GBC180 Air Conditioner is experiencing a cooling failure?
If your Trane Air Conditioner has a cooling failure, check CC1 and CC2 coils and the Frostat™ status. Also, check the status of the LED indicator in LSD. Another solution is to power cycle on the ‘R’ input.
General| Brand | Trane |
|---|---|
| Model | Foundation GBC180 |
| Category | Air Conditioner |
| Language | English |
Covers advisories, PPE, wiring, grounding, and EHS policies for safe operation.
Details environmental impact of chemicals and responsible refrigerant handling practices.
Explains the manual's scope and the importance of regular maintenance for unit performance.
Explains how each digit defines unit type, capacity, controls, and options.
Covers procedures for inspecting units upon receipt and proper storage methods.
Details economizer actuators, system inputs, safety devices, and sensors.
Explains thermostat compatibility, CO2, and occupancy sensor integration with JADE controller.
Provides clearance requirements and typical installation layouts for single and multiple units.
Displays various unit views with critical dimensions for different configurations.
Details dimensions for roof curb mounting and downflow duct connection interfaces.
Presents unit weights and corner weight data for different models.
Warns about heavy object handling and outlines safe rigging procedures for lifting units.
Covers requirements for roof collapse prevention, unit foundation, and level installation.
Details ductwork attachment, flexible connectors, and waterproofing requirements.
Outlines essential safety and compliance steps for field electrical wiring.
Covers installation checklist, economizer setup, and main electrical power requirements.
Details vent hood installation, TCO1 replacement, and condensate drain setup.
Guides on filter installation, power wiring entrance, conductor sizing, and control wiring.
Outlines gas piping requirements, leak testing, and drip leg installation for safe operation.
Provides operating data for gas heaters, including input rates and pressure specifications.
Explains how to measure and calculate voltage imbalance and its impact on motors.
Describes how to check electrical phasing for motors and associated safety warnings.
Explains crankcase heater function for compressor oil and proper start-up procedures.
Details safety precautions for units with factory-mounted disconnect switches, including capacitor discharge.
Details the sequence of operation for electromechanical control systems.
Guides on setting up standard economizers and their cooling operation.
Explains various cooling modes, fan speed control, and economizer minimum position.
Covers phase monitors, pressure cutouts, frost protection, and FDD certifications.
Details JADE controller sequences and standard economizer start-up procedures.
Provides instructions for adjusting belt tension using a tension gauge and specific ranges.
Lists checks for filters, condensate overflow switch, and coils during monthly maintenance.
Outlines checks for heating season, coil cleaning, and hazardous chemical handling.
Guides on checking ignition module status, system failures, and lockout resets.
Covers troubleshooting for low leak economizers, FDD faults, and alarm clearing.
Explains how to access wiring diagrams via e-Library and lists available diagrams.
Details warranty coverage for equipment rated 25 tons and under.
Lists conditions and limitations that void the warranty, including accident and abuse.
