To Next PageTo Next PageHow to reset cooling and heating lockouts on a Trane Foundation GBC300 Air Conditioner?
To reset cooling and heating lockouts, turn the 'Mode' selection switch at the thermostat to the 'Off' position. After approximately 30 seconds, turn the 'Mode' selection switch to the desired mode, such as Heat, Cool, or Auto. Alternatively, cycle the unit power by turning the disconnect switch 'Off' and then 'On'.
What to do if my Trane Air Conditioner is experiencing a cooling failure?
If your Trane Air Conditioner has a cooling failure, check CC1 and CC2 coils and the Frostat™ status. Also, check the status of the LED indicator in LSD. Another solution is to power cycle on the ‘R’ input.
General| Brand | Trane |
|---|---|
| Model | Foundation GBC300 |
| Category | Air Conditioner |
| Language | English |
Overview of manual, safety warnings, environmental concerns, and refrigerant practices.
Details unit model number, general info, inspection, and storage procedures.
Provides unit dimensions, clearances, weights, and rigging information.
Guidance on unit foundation, ductwork, and essential installation checks.
Covers main power, wiring, grounding, and gas heat connection requirements.
Details TCO1 controls, drain configuration, voltage, phasing, and heater installation.
Verifying airflow and setting up electromechanical controls before initial startup.
How electromechanical controls manage cooling and fan operation modes.
Details on using the economizer and unit behavior during cooling scenarios.
Final checks of settings, connections, and unit security before commencing operation.
Fan belt adjustment, monthly checks for filters, condensate, coils, and electrical components.
Guidelines for coil cleaning and diagnosing common unit failures and alarms.
Procedures for resetting system lockouts after failures or safety trips.
Reference for electrical schematics and connection diagrams for unit configurations.
Details on product coverage, limitations, and claims procedures.
