AMS-SVX02A-EN 15
Unit Installation
Attentions
Improper screw tightness may cause fault as shown in fi g. 7.1.
Air leakage
Ceiling air leakage
Water drop condensed and fall
Figure 7.
If there is still a seam between ceiling and decoration panel after tightening screws, please 2.
adjust the indoor unit height again (as shown in fi g. 8).
No seams
Without affecting the indoor unit lifting
and drainage pipe are prerequisites for
adjusting the height through holes at
the panel corner.
Figure 8.
ř Ensure no clearances between the unit and panel after installation.
Decoration panel wiring (see fi g. 9).3.
Connect two joints of air defl ector motor at the panel.•
Main Panel
Main Panel
Figure 9.
To Next Page
Loading...
