Introduction
CLCH-SVX08C-EN 3
Copyright
This document and the information in it are the property of
Trane, and may not be used or reproduced in whole or in
part without written permission. Trane reserves the right
to revise this publication at any time, and to make changes
to its content without obligation to notify any person of
such revision or change.
Trademarks
All trademarks referenced in this document are the
trademarks of their respective owners.
Revision History
• Updated Performance air handler section nameplate
figure in Introduction chapter.
• Changed 0 to 10 Vdc to 2 to 10 Vdc in Installation
chapter.
• Updated Flue connection sizes for gas heat sections
figure in Installation chapter.
• Updated Duct Connection section in Installation
chapter.
• Added Gas heat internal piping penetration location
and Gas heat external piping penetration location
figures in Piping chapter.
• Updated Airflow direction label figure in Installation
chapter.
• Added Gas heat-Power exhaust figure in Wiring
chapter.
WARNING
Follow EHS Policies!
Failure to follow instructions below could result in
death or serious injury.
• All Trane personnel must follow the company’s
Environmental, Health and Safety (EHS) policies
when performing work such as hot work, electrical,
fall protection, lockout/tagout, refrigerant handling,
etc. Where local regulations are more stringent than
these policies, those regulations supersede these
policies.
• Non-Trane personnel should always follow local
regulations.
To Next Page
Loading...
