Trane Perfomance Climate Changer CSAA006UAC00 User Manual

SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing
of heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and
training. Improperly installed, adjusted or altered equipment by an unqualified person could result in death or
serious injury. When working on the equipment, observe all precautions in the literature and on the tags,
stickers, and labels that are attached to the equipment.
Installation, Operation,
and Maintenance
Gas Heat
Performance Climate Changer™ CSAA Air Handlers
Sizes 6-120 for Indoor and Outdoor Units
CLCH-SVX08C-EN
February 2020

Trane Perfomance Climate Changer CSAA006UAC00 Specifications

General

Model	CSAA006UAC00
Category	Air Handlers
Airflow Capacity	600 CFM
Cooling Capacity	6, 000 BTU/hr
Heating Capacity	5, 000 BTU/hr
Refrigerant Type	R-410A
Nominal Airflow	600 CFM
Voltage	208/230V
Phase	1
Motor Type	ECM
Filter Type	MERV 8
Cabinet Construction	Galvanized Steel
Insulation	Fiberglass

Summary

Introduction to Gas Heat Air Handlers

Safety Advisories Explained

Defines WARNING, CAUTION, and NOTICE advisories used to convey safety information.

Pre-Installation Procedures

Receiving and Handling Guidelines

Provides crucial steps for inspecting and handling the unit upon delivery to the job site.

Shipment Inspection Process

Details how to check for completeness and identify any shipping damage to the unit components.

Unit Dimensions and Weights

Installation Procedures

Contractor Responsibilities Overview

Defines the roles and responsibilities for installing and electrical/controls contractors.

Installing Contractor Duties

Details tasks for the installing contractor, including rigging, flue stack, and gas connections.

Electrical and Controls Contractor Duties

Lists responsibilities for providing power, signals, and ensuring proper wiring compliance.

Lifting and Rigging Guidance

Placement and Assembly Steps

High Altitude Installation Adjustments

Duct Connections and Requirements

Piping Installation and Gas Pressure

Gas Piping Installation Standards

Outlines the standards and practices required for safe and compliant gas piping installation.

Maintaining Proper Gas Pressure

Details the critical importance of correct gas supply pressure and regulator requirements for operation.

Electrical Wiring Requirements

Field Wiring Checklist

Lists essential checks and compliance requirements for proper field wiring installation.

High-Voltage Wiring Considerations

Low-Voltage Control Wiring

Unit Start-Up Procedures

Startup Safety Warnings

Highlights critical safety warnings regarding hazardous gases, voltage, and explosion risks during startup.

Pre-Startup Checklist

Unit Operation Verification

Pre-Purge and Pilot Ignition Sequence

Main Burner Ignition Process

Explains the procedure for igniting the main burner and checking flame signal strength.

20:1 Turndown Ignition

Covers the pre-purge and main flame ignition sequence specific to 20:1 turndown unit models.

Final Operational Check

Lists final checks for gas pressure, emissions, and overall system performance after startup.

Seasonal Startup and Shutdown

First Seasonal Startup

Routine Maintenance Procedures

Heating Mode Maintenance Tasks

Maintenance for Trained Personnel

Troubleshooting Gas Heat Sections

Safety Precautions for Service

Warns about potential electrical, mechanical, and gas hazards during maintenance and troubleshooting.

Fuel Gas Hazards During Service

Reinforces warnings about exposure to hazardous fuel gases and flammable vapors during troubleshooting.

Troubleshooting Common Issues (Part 1)

Provides a table of symptoms, probable causes, and recommended actions for common gas heat section problems.

Troubleshooting Common Issues (Part 2)

Continues the table of symptoms, causes, and recommended actions for diagnosing gas heat section issues.