Trane RAU-SVX01B-E4 - Control Parameters of the SMM Control Module

26 RAU-SVX01B-E4
Control parameters of the SMM control module
To cancel a manually reset default press key 1.
A
A01 Active Evap. discharge air set point
A02 Evaporator Evap. discharge air outlet mix
temperature
A03 Circuit 1 evaporator Evap. discharge air
outlet temperature
A04 Circuit 2 evaporator Evap. discharge air
outlet temperature
A05 Air temperature
A06 Number of compressor A1 operating
hours
A07 Number of compressor A1 starts
A08 Number of compressor B1 operating
hours
A09 Number of compressor B1 starts
A10 Number of compressor A2 operating
hours
A11 Number of compressor A2 starts
A12 Number of compressor B2 operating
hours
A13 Number of compressor B2 starts
B
B01 Evaporator outlet temperature set point
B02 Not used
B03 Auxiliary discharge air temperature set
point
B04 Circuit 1 ON validation
B05 Circuit 2 ON validation
B06 Operating mode
B07 Remote control validation
B08 Auxiliary set point validation
B09 Current date display
B091 Day
B092 Month
B093 Year
B10 Current time display
B101 Hours
B102 Minutes
B103 Seconds
B11 Set this parameter to 0.0 °C
B12 Set this parameter to 0.0°C
B13 Set this parameter to 0.0°C
C
C01 Default display
C02 Current default reset
D
D01 Cooling set point reset type
D02 Cooling reset starting value
D03 Cooling reset value range
D04 Cooling reset range
D05 Not used
D06 Not used
D07 Not used
D08 Not used
D09 Generic input type
D10 Not used
D11 Not used
D12 Compressor lead-lag
D13 Default 1 report type
D14 Default 2 report type
D15 Serial link address
E
E01 Circuit 1 evaporator saturated temperature
E02 Circuit 1 evaporator saturated pressure
E03 Circuit 1 condenser saturated temperature
E04 Circuit 1 condenser saturated pressure
E05 Circuit 2 evaporator saturated temperature
E06 Circuit 2 evaporator saturated pressure
E07 Circuit 2 condenser saturated temperature
E08 Circuit 2 condenser saturated pressure
E09 Evaporator air inlet temperature
E10 Not used
E11 Not used