EasyManua.ls Logo

Trane RAUC-IOM-15 User Manual

Trane RAUC-IOM-15
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Since the manufacturer has a policy of continuous product
improvement, it reserves the right to change specifications and
design without notice.
TM
Remote Split System Units
Air Cooled Condensing Units and
EVP Chillers
Installation RAUC-IOM-15
Operation
Maintenance
Library Service Literature
Product Section Unitary
Product Split System Air Conditioning (80 - 120 Tons)
Model RAUC
Literature Type Installation/Operation/Maintenance
Sequence 15
Date March 2006
File No. SV-UN-S/S-RAUC-IOM-15 03/06
Supersedes December 2001
© American Standard Inc, 2001
http://www.trane.com
Models
"L" and Later Design Sequence
RAUC-C80
RAUC-D10
RAUC-D12
Note: The installation of this equipment must
comply with all National, State, and Local
Codes.

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Trane RAUC-IOM-15 and is the answer not in the manual?

Trane RAUC-IOM-15 Specifications

General IconGeneral
BrandTrane
ModelRAUC-IOM-15
CategoryAir Conditioner
LanguageEnglish

Summary

About The Manual and Literature History

Overview of Manual

Describes proper installation, operation, and maintenance procedures for air cooled systems.

Literature Change History

Details revisions made to the manual across different versions.

General Information and Unit Identification

Model Number Description

Explains the meaning of each digit in the unit's model number.

Unit Nameplate Information

Details location and importance of information on the unit nameplate.

Component Nameplates (Compressor, Evaporator)

Location and information on specific component nameplates.

Hazard Identification and Warnings

Highlights potential hazards and safety precautions for installation and operation.

Unit Component Layout and Locations

Visual representation of unit components and their placement.

Installation Procedures

Pre-Installation Checks (Inspection, Clearances, Dimensions, Foundation)

Covers unit inspection, clearances, dimensions, weight, and foundation requirements.

Piping Installation (Refrigerant & Chilled Water)

Guidelines for sizing and installing refrigerant and chilled water piping.

Electrical Wiring and Power Requirements

Instructions for main power wiring and sizing.

Control Wiring Requirements

Guidelines for various control wiring configurations for different unit options.

System Pre-Start Procedures

Critical steps to perform before starting the unit for the first time.

System Start-Up and Operation

Sequence of Operation (VAV & EVP Controllers)

Explains how controllers manage system operation based on temperature and conditions.

Compressor and Fan Operation Details

Details condenser fan, crankcase heater, pump down, and HGBP operation.

Low Ambient Operation and Dampers

How low ambient dampers extend unit operation to lower temperatures.

Compressor Start-Up and Performance Checks

Steps for starting compressors, checking rotation, pressures, superheat, and sub-cooling.

Final System Setup and Checks

Final checks before leaving the unit after start-up.

Service & Maintenance

Compressor-Related Maintenance

Covers compressor sounds, replacement, and oil checks.

Fuse Replacement and Monthly Checks

Lists replacement fuses and outlines monthly maintenance tasks.

Coil Cleaning and System Operation Verification

Procedures for cleaning coils and verifying system operation post-maintenance.

Related product manuals