To Next PageTo Next Page
Need help?Do you have a question about the Trane S8B1B040M2PSC and is the answer not in the manual?
General| Model Number | S8B1B040M2PSC |
|---|---|
| Category | Furnace |
| Type | Gas |
| Input BTU | 40, 000 |
| Output BTU | 32, 000 |
| Efficiency | 80% |
| Stages | 1 |
| Fuel Type | Natural Gas |
| Warranty | 10 years |
Warnings about fire, explosion, and gas leaks, including safety procedures.
Warnings against storing flammables near the unit and using specific gas connectors.
Caution regarding sharp edges and the need for a backup wrench on gas valves.
Warning about UV light damaging plastic blower housing and preventing exposure.
Precautions for electrical shock during servicing and operation.
Propane gas hazards, leak detection, and manual lighting prohibition.
Precautions for high voltage components, moving parts, and servicing.
Precautions against freeze-up and maintaining manifold pressure for ignition.
Steps for operating appliances connected to the venting system safely to prevent CO poisoning.
Hazards related to carbon monoxide and proper venting.
Warnings about electrical shock and safe operation of controls.
Prohibitions on unlined masonry chimneys and inspection of liners.
Recommendations for condensate drains and caution about hot igniters.
Warning about furnace placement on combustible flooring.
Restrictions on use in mobile housing and procedures for equipment failure.
Disconnecting power before servicing and procedures for overheating.
Labeling wires for service and not using the furnace as a construction heater.
Caution against connecting to GFCI circuits and installing in corrosive atmospheres.
Polarity sensitivity of the integrated furnace control and connection requirements.
Essential safety practices and precautions for furnace installation and servicing.
List of airborne contaminants that can cause furnace issues and require specific ventilation.
Detailed wiring diagram for S8B1 furnace models including IFC and components.
Detailed wiring diagram for S8X1 furnace models including IFC and components.
Detailed wiring diagram for S8X2 furnace models including IFC and components.
Diagrams and notes for connecting gas piping in various furnace orientations.
Diagrams for horizontal furnace installations with different gas piping outlets.
Table for natural gas pipe sizing and main burner orifice drill sizes.
Procedure for checking gas flow and input rate, including gas flow tables.
Instructions for adjusting gas valve manifold pressure for natural gas and propane.
Information on adjusting input rates and orifice sizes for high altitude installations.
Guidelines for furnace venting systems, including masonry chimneys.
Tables and guidelines for venting through masonry chimneys and vent termination heights.
Requirements for adequate airflow for combustion and ventilation, including unconfined spaces.
Diagrams illustrating ventilation requirements for confined spaces.
Warning about chimney liner integrity and potential carbon monoxide leaks.
