To Next PageTo Next Page
Need help?Do you have a question about the Trane S8B1B080M4PSBA and is the answer not in the manual?
General| Model Number | S8B1B080M4PSBA |
|---|---|
| Category | Furnace |
| Type | Gas |
| Heating Capacity | 80, 000 BTU |
| Efficiency Rating | High Efficiency |
| AFUE | 80% |
| Fuel Type | Natural Gas |
| Stages | Single Stage |
| Gas Valve Type | Standard |
| Ignition Type | Hot Surface Ignition |
| Filter Size | 16 x 25 x 1 inches |
| BTU Output | 80, 000 BTU |
| Warranty | 10 years |
Crucial safety warning regarding hazardous operation and potential injury or death.
Warnings about fire, explosion, and electrical shock risks during installation and service.
Warnings related to carbon monoxide poisoning and proper venting.
Information on chemicals known to cause cancer and birth defects in California.
Covers hazards like explosion, shock, overheating, and improper voltage connections.
Details on sharp edges, wrench use, freeze protection, and ignition function.
Essential safety practices for furnace installation, servicing, and operation.
Manufacturer's responsibilities and adherence to codes for installation.
Specifies required clearances to combustible materials for furnace placement.
Dimensional drawings for the 17.5" width cabinet furnace.
Dimensional drawings for the 24.5" width cabinet furnace.
Instructions for removing furnace access panels for service.
Guidelines for installing the furnace in an attic or crawlspace horizontally.
Details and diagrams for connecting the gas supply to the furnace.
Tables for natural gas pipe sizing and orifice sizes for burners.
Procedures for checking gas flow rate and input rating.
Step-by-step guide for adjusting gas valve manifold pressure.
Instructions for adjusting furnace input rating at high altitudes.
Guidelines for venting the furnace exhaust system.
Requirements for adequate airflow for combustion and ventilation.
Instructions for connecting supply and return air ducts to the furnace.
Guidelines for connecting return air ducting to the furnace.
Information on typical air filter installations and preparation.
Instructions for making electrical connections to the furnace.
Wiring diagrams for single-stage and two-stage thermostats.
Connection diagrams for twinning two S-Series furnaces.
Procedures for general start-up and adjustment of the gas furnace.
Approved venting options for upflow furnace orientations.
Approved venting options for horizontal left and right furnaces.
Approved venting options for downflow furnace orientations.
Instructions for converting combustion air exhaust orientation.
Diagram and explanation of the furnace control system menu.
Steps for setting up the system, clearing faults, and selecting speeds.
Procedure for entering and using the furnace run test mode.
Explanation of system status codes displayed on the IFC.
Guide to measuring and setting furnace airflow based on ESP.
List of integrated furnace control display codes and their explanations.
Procedure for viewing, clearing, and resetting fault codes.
Detailed sequence for 1st stage gas heating operation.
Detailed sequence for 2nd stage gas heating operation on S8X2 models.
Sequence of operation for single stage cooling.
Sequence of operation for two stage cooling.
