Trane S8B1B060M4PSAB User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
March 2020
1188--CCEE1144DD11--11AA--EENN
Upflow/Downflow/Horizontal
Gas-Fired, 1–Stage and 2–Stage Induced Draft Furnaces with
High Efficiency Motor
UUppffllooww,, DDoowwnnffllooww,, HHoorriizzoonnttaall RRiigghhtt//LLeefftt
Single Stage Two Stage
S8B1
S8X1
S8X2
S8B1A026M2PSAB
S8B1A040M3PSAB
S8B1B040M2PSAB
S8B1B060M3PSAB
S8B1B060M4PSAB
S8B1B080M4PSAB
S8B1C080M5PSAB
S8B1C100M5PSAB
S8B1D120M5PSAB
S8X1A026M2PSAB
S8X1A040M3PSAB
S8X1B040M2PSAB
S8X1B060M3PSAB
S8X1B060M4PSAB
S8X1B080M4PSAB
S8X1C080M5PSAB
S8X1C100M5PSAB
S8X1D120M5PSAB
S8X2A040M3PSAB
S8X2B060M3PSAB
S8X2B060M4PSAB
S8X2B080M4PSAB
S8X2C080M5PSAB
S8X2C100M5PSAB
S8X2D120M5PSAB
NNoottee:: This installer’s Guide is used for multiple furnace families. Models may
have a “T” in the 12th digit designating they meet California less than 40
ng/J (NOx) emissions requirements.
NNoottee:: Graphics in this document are for
representation only. Actual model may
differ in appearance.
18-CE14D1-1A-EN
Installer’s Guide

Trane S8B1B060M4PSAB Specifications

General

Model Number	S8B1B060M4PSAB
Category	Furnace
Type	Gas
Heating Capacity	60, 000 BTU
Input BTU	60, 000 BTU
Output BTU	48, 000 BTU
Efficiency	80%
AFUE	80%
Blower Motor	PSC
Blower Type	Multi-Speed
Stages	Single Stage
Fuel Type	Natural Gas
Ignition	Hot Surface
Warranty	5-Year Parts

Summary

Furnace Installation Guidelines

Safety Practices and Precautions

Follow safety practices and precautions for installation, servicing, and operation.

Locations and Clearances

Furnace General Installation

Gas Piping

Details on furnace gas piping connections, including default left side and alternate right side.

Combustion and Input Check

Procedures for checking gas flow rate and input using the gas meter.

Gas Valve Adjustment

Steps for adjusting manifold pressure for 1st and 2nd stage gas heat.

High Altitude Derate

General Venting

Guidelines for venting systems, including masonry and external chimneys.

Air for Combustion and Ventilation

Requirements for providing adequate combustion and ventilation air for furnace operation.

Duct Connections

Electrical Connections

Instructions for making wiring connections to the unit.

General Start-up and Adjustment

Preliminary Inspections

Checks to perform before starting up the furnace, including gas leak checks.

Lighting Instructions

Control and Safety Switch Adjustment

Integrated Furnace Control Display Codes

Fault Code Recovery

Sequence of Operation S8B1/S8X1/S8X2

1st Stage Gas Heating

Step-by-step sequence for 1st stage gas heating operation.

2nd Stage Gas Heating (S8X2 Only)

Single Stage Cooling

Two Stage Cooling

Single Stage Heat Pump

Two Stage Heat Pump