EasyManua.ls Logo

Trane S8X1B060M3PSAB User Manual

Trane S8X1B060M3PSAB
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
May 2020
1188--CCEE0044DD11--11DD--EENN
Upflow/Downflow/Horizontal
Gas-Fired, 1–Stage and 2–Stage Induced Draft Furnaces with
High Efficiency Motor
UUppffllooww,, DDoowwnnffllooww,, HHoorriizzoonnttaall RRiigghhtt//LLeefftt
Single Stage
S8X1A026M2PSAB
S8X1A040M3PSAB
S8X1B040M2PSAB
S8X1B060M3PSAB
S8X1B060M4PSAB
S8X1B080M4PSAB
S8X1C080M5PSAB
S8X1C100M5PSAB
S8X1D120M5PSAB
Two Stage
S8X2A040M3PSAB
S8X2B060M3PSAB
S8X2B060M4PSAB
S8X2B080M4PSAB
S8X2C080M5PSAB
S8X2C100M5PSAB
S8X2D120M5PSAB
S8X1
S8X2
NNoottee:: This installer’s Guide is used for multiple furnace families. Models
may have a “T” in the 12th digit designating they meet California less
than 40 ng/J (NOx) emissions requirements.
NNoottee:: Graphics in this document are for
representation only. Actual model may
differ in appearance.
18-CE04D1-1D-EN
Installer’s Guide
Question and Answer IconNeed help?

Do you have a question about the Trane S8X1B060M3PSAB and is the answer not in the manual?

Trane S8X1B060M3PSAB Specifications

General IconGeneral
ModelS8X1B060M3PSAB
TypeGas Furnace
Efficiency Rating80% AFUE
StagesSingle Stage
Blower MotorPSC
Fuel TypeNatural Gas
BTU Input60, 000 BTU
BTU Output48, 000 BTU
Ignition TypeHot Surface Ignition
Heat Exchanger MaterialAluminized Steel
Heating Capacity60, 000 BTU
Warranty5-Year Limited Warranty on Parts
Vent Diameter4 inches

Summary

Safety Section Non-Condensing Furnaces

Fire, Explosion, and Gas Hazards

Warnings concerning fire, explosion, gas leaks, and combustible materials.

Electrical Safety

Warnings regarding electrical shock and safe servicing practices.

Carbon Monoxide and Venting Hazards

Hazards associated with carbon monoxide and improper venting.

Installation and Operational Safety

California Prop 65 and Specific Hazard Warnings

Prop 65, propane explosion, electrical, manual lighting, and mobile home installation hazards.

Component Handling and Maintenance Precautions

Precautions for Sharp Edges, Freeze Protection, and Hot Surfaces

Precautions for sharp edges, freeze protection, hot surfaces, and furnace servicing.

Furnace Installation Guidelines

Safety Practices and Precautions

Essential safety rules for furnace installation and servicing.

Locations and Clearances

Requirements for furnace placement and clearances to combustibles.

Furnace Placement Restrictions

Guidelines for furnace location, including garages and prohibited environments.

Furnace General Installation

Gas Piping

Gas Piping - Horizontal Orientations

Diagrams for gas piping in horizontal furnace orientations.

Combustion and Input Check

Gas Valve Adjustment

General Venting

Air for Combustion and Ventilation

Duct Connections

Electrical Connections

Field Wiring Diagrams

Diagrams illustrating thermostat and furnace wiring.

General Start-up and Adjustment

Preliminary Inspections

Checks to perform before starting up the furnace.

Lighting Instructions

Steps for safely lighting the furnace.

Control and Safety Switch Adjustment

Checking limit switches and safety controls.

Furnace Combustion Air Exhaust Options

Venting Options for Upflow Applications

Approved venting configurations for upflow furnaces.

Venting Options for Horizontal Left Applications

Approved venting configurations for horizontal left furnaces.

Integrated Furnace Control Menu

Setting Airflow

Integrated Furnace Control Display Codes

Fault Code Recovery

Sequence of Operation S8X1/S8X2

1st Stage Gas Heating

Detailed sequence for 1st stage gas heating operation.

2nd Stage Gas Heating (S8X2 Only)

Sequence for 2nd stage gas heating for S8X2 models.

Single Stage Cooling

Sequence for single stage cooling operation.

Two Stage Cooling

Sequence for two stage cooling operation.

Single Stage Heat Pump

Sequence for single stage heat pump operation.

Two Stage Heat Pump

Sequence for two stage heat pump operation.

Related product manuals