To Next PageTo Next Page
Need help?Do you have a question about the Trane S8X2B080M4PSAB and is the answer not in the manual?
General| Model | S8X2B080M4PSAB |
|---|---|
| Type | Gas Furnace |
| Heating Capacity | 80, 000 BTU |
| Efficiency Rating | 80% AFUE |
| Blower Type | Multi-speed |
| Fuel Type | Natural Gas |
| Stages | Single Stage |
| BTU Input | 80, 000 BTU |
| BTU Output | 64, 000 BTU |
| Ignition | Hot Surface Ignition |
Warning about fire or explosion from improper handling of flammable materials and gas.
Warning regarding electrical hazards, fire, and explosion during servicing.
Warning about carbon monoxide poisoning due to improper venting.
Hazard warning related to ensuring adequate venting for the new furnace.
Warning against installing furnace on combustible flooring without a subbase.
Warning about potential explosion from gas leaks and improper testing methods.
Warning for propane installations regarding gas collection in low areas and odorant fade.
Warning against bypassing the door switch or panel loop by any permanent means.
Warning not to touch components other than specific buttons when setting up the system.
Warning against attempting to manually light the furnace.
Warning to follow maintenance instructions for furnace and venting system.
Warning to ensure the blower door is in place to prevent dangerous fumes.
Warning to disconnect power before servicing and allow discharge time.
Warning that furnaces are not approved for mobile housing, trailers, or RVs.
Instruction to shut off gas supply during failures before electrical power.
Warning not to store flammable materials near the unit.
Warning against using semi-rigid metallic gas connectors within the furnace cabinet.
Warning about injury from high voltage, moving fans, and gas during installation.
Prohibition of furnace venting into unlined masonry or concrete chimneys.
Requirement to inspect chimney liner for cracks to prevent flue gas leaks.
Instruction to lock disconnect switch in open position before servicing.
Instruction to shut off gas valve if overheating occurs or gas supply fails.
Warning about CO poisoning from improper venting procedures during startup.
Essential safety practices to follow during installation, servicing, and operation.
Explanation of alarm error codes and their corresponding alarm conditions.
Procedures for viewing, clearing, and resetting fault codes on the IFC.
Detailed sequence of operation for 1st stage gas heating for S8X1 and S8X2 furnaces.
