18-GJ89D1-1D-EN
31
3. Remove the control board from the control pocket by sliding the
control pocket mounting plate out until the first stop is reached.
4. After installing the 18 gauge thermostat wire into the CAN
connector, plug the connector onto the AHC board in either the J2
or J5 location, the outdoor control wiring will plug into the other
header on the AHC.
For Horizontal Right Installations Only
5. Remove the control board completely from the control pocket.
Rotate the control board 180 degrees. Place the control board 2–3
inches back into the control pocket.
6. Make connections per hookup diagrams.
Important: After wires have been connected or service performed,
the control board MUST be rotated back to the original
orientation before inserting into cabinet control pocket.
EElleeccttrriiccaall —— LLooww VVoollttaaggee
To Next Page
Loading...
